Furnace Replacement & Installation in Philadelphia & New Jersey

Very few people replace a furnace because they want to. They get there after a repair quote that is a large fraction of a new system, or after a technician finds a cracked heat exchanger, or after the third winter of nursing a system that was already old when they bought the house. The question at that point is not whether the furnace can be patched once more, it is which of the two numbers is cheaper over the next ten years.

Synergy3 Home Solutions has been replacing and installing heating systems across Greater Philadelphia and New Jersey since 2006. Our NATE-certified technicians size the equipment to the actual house rather than copying whatever was there, put good, better and best options in writing, and quote the job for free. If you are weighing a repair against a replacement, we will price both.

Signs It Is Time to Replace Your Furnace

• The furnace is 15 to 20 years old or more
• You have paid for two or more repairs in the last couple of winters
• A major component has failed: heat exchanger, blower motor or control board
• Heating bills keep climbing while your usage has not changed
• Some rooms never get warm no matter what the thermostat says
• The furnace is noticeably louder than it used to be
• The burner flame is yellow rather than blue, or the system soots up repeatedly
• Parts are getting hard to source for the model

A cracked heat exchanger is the one item on this list that is not a judgement call. It is a combustion safety issue, and the answer is replacement. Everything else is a comparison of numbers, and we will give you both. If the system is simply down, start with Furnace Repair.

Systems We Install

High-Efficiency Gas Furnaces

The standard replacement for most homes in the region. Higher-efficiency models extract more heat from the same fuel, which shows up on the bill every month for the life of the system, and modulating models hold a steadier temperature instead of swinging between hot and cold.

Boilers

For homes on hot water or steam, where replacing the boiler is only half the job. We look at the distribution too, the radiators, valves and circulator, because a new boiler feeding a system with air-bound radiators still leaves rooms cold. We install Bosch boilers on the hydronic side.

Heat Pumps

One system that heats and cools, and worth pricing whenever the air conditioner is a similar age to the furnace, since you would otherwise be paying for two separate installations a year or two apart.

Ductless Mini-Splits

For homes without ductwork, finished attics, additions and rooms the existing system never reached. Each indoor head is controlled separately, so you are not heating rooms nobody is in.

How We Size and Quote a New System

The most expensive mistake in this trade is sizing by square footage. An oversized furnace heats fast, shuts off early and short cycles for the rest of its life, which is why an oversized system can leave a house both uncomfortable and expensive to run.

Our estimates start with a load calculation on the actual house: size, layout, insulation, windows and orientation. We check the ductwork and returns, since replacing equipment without addressing an airflow restriction carries the problem straight into the new system. Then you get written options, usually three, with the price, the efficiency rating and the trade-offs of each spelled out. The estimate is free and carries no obligation.

What Installation Day Looks Like

• Protection and prep. Floors and pathways are covered before anything is carried in or out.
• Removal of the old system. We disconnect and haul away the old equipment. You do not have to arrange disposal.
• Installation. New equipment set and connected, along with any venting, gas line or duct corrections identified in the estimate.
• Permits and inspection. Where the municipality requires them, we handle the paperwork.
• Start-up and testing. Combustion, airflow and temperature rise are measured and adjusted rather than assumed.
• Cleanup and walkthrough. The work area is left clean and a technician walks you through the thermostat, the filter schedule and what the system should sound like.

A straightforward furnace changeout is usually a single day. Boiler replacements, a switch to a heat pump, venting changes or ductwork corrections can take longer, and we tell you which one yours is at the estimate rather than on the morning of the install.

Cost and Financing

What a replacement costs depends on the capacity the house needs, the efficiency level you choose, whether venting or ductwork needs work and how accessible the equipment location is. Anyone quoting a firm price before seeing the house is guessing, and that guess tends to reappear later as a change order.

The money side we can describe upfront. Estimates are free. You get good, better and best options in writing rather than a single figure. Financing is available with approved credit, including 0% options, and our current promotion takes $1,000 off full system replacements. All of it is covered during the estimate, so the monthly number is part of the decision rather than a surprise afterwards.

Service Areas

We install heating systems out of offices in Philadelphia and New Jersey, covering Greater Philadelphia along with much of South and Central Jersey, including Conshohocken, Jenkintown, Bensalem, Cherry Hill and Haddonfield. The full list is on our Service Areas page. Our hours are Monday to Friday 7am to 7pm and Saturday 7am to 3pm.

Our Guarantees

Every installation carries a one-year parts and labor warranty from us, on top of the manufacturer warranty, which we register on your behalf so coverage is not lost to missing paperwork. The work is backed by our 365-day satisfaction guarantee. Technicians on your job are NATE-certified, and our BPI-certified crews can tell when the reason a room never gets warm is the building envelope rather than the equipment, which occasionally saves people from buying a larger furnace than they need.

Why Philadelphia and New Jersey Homeowners Choose Synergy3 Home Solutions

Synergy3 Home Solutions opened in Philadelphia in 2006 and is still family-run, coming up on 20 years of installing and servicing heating systems here. More than 2,000 customers and a 4.9-star average across 500+ Google reviews is the record behind that. Heating, cooling, plumbing and insulation sit under one company, which matters on a replacement: if the cold bedroom is an insulation problem, we would rather tell you than sell you more furnace.

Schedule Your Free Estimate

Call 267-802-3026 or send a request through the site. We will come out, look at the house and the existing system, run the numbers and put your options in writing. There is no charge for the estimate and no obligation to book the work.